Protection from UV Rays
Ceramic Cover CC Systems 100 can be applied directly over composites with 100% adhesion and no chemical adverse effect (i.e. tar roofing, asphalt shingles, paint, etc.) providing protection against UV Rays as well as insulating.
Action Testing, Inc., a certified testing laboratory in Tucker, GA reported "coating material found to be extremely durable and high quality, 'heat barrier' and reflected 95% to 98% of all radiant heat. The high percentage of radiant heat reflected would be comparable to a rating of R-20 at a 13 mil thickness." Additional testing by Action Testing, Inc. was performed on 1 inch of foam coated with 16 mils of Ceramic Cover CC Systems 100.
"The Envirotrol coating offers protection against the normal problems of foam, therefore, it preserves the effectiveness of such insulating materials."Foam has a tendency to crumble and split when exposed to ultra violent rays. However, when the foam was covered with a thin coat of Ceramic Cover CC Systems 100 and tested; the conclusion reported: "The Envirotrol coating offers protection against the normal problems of foam, therefore, it preserves the effectiveness of such insulating materials.
The coating was also found to remain flexible at temperatures as low as -30º F, also this additional coating on 1.00 pcf density foam provides the dimensional stability and compressive strength normally found in higher cost 3.0 pcf densities without paying the higher price".
Ceramic Cover CC System 100
Insulation
Test results have proven that one coat or 20 mil of Ceramic Cover CC Systems 100 eliminates radiant heat and reduces temperature greatly (60ºF to 80ºF degrees) on hot surfaces. Additional coats contribute a reduction in temperature between 40ºF to 45ºF.
Protection from UV Rays
Ceramic Cover CC Systems 100 can be applied directly over composites with 100% adhesion and no chemical adverse effect (i.e. tar roofing, asphalt shingles, paint, etc.) providing protection against UV Rays as well as insulating.
Adhesion
Ceramic Cover CC Systems 100 reaches full adhesive strength prior to final cure. Also based on disbondment within the coating, Ceramic Cover CC Systems 100 shows an actual stronger bond to the substrate surface.
Flame Resistance
Ceramic Cover CC Systems 100 flame spread is rated 5 out of 100 according to Southwest Research Institute, Department of Fire Technology in San Antonio, TX and MSDS sheet reports flash point noncombustible. Therefore, Ceramic Cover CC Systems 100 can be applied directly to hot surfaces in a wide temperature ranging from 34ºF to 400ºF without shut down.
Corrosion Protection
Ceramic Cover CC Systems 100 has no air pockets, therefore it impedes condensation, stops corrosion and has no loss of insulation properties when wet.
Condensation
Ceramic Cover CC Systems 100 has properties that are impervious to the environment such as a fungal-pesticide resistance - rating of 10 on a scale of 1 to 10 (10 being the highest). Additional tests have been administered: wind driven rain, hot/cold cycling, and chemical resistance. In each test and/or analysis, Ceramic Cover CC Systems 100 "tested in the highest percentiles" of available products.
Chemical Resistance
Ceramic Cover CC Systems 100 is an 84% solid latex high density material low in viscosity coating with high insulating properties and chemical resistance.
Chemical Content
Harland Associates Research Lab in San Francisco, CA, reports Ceramic Cover CC Systems 100 as having
0 (zero) grams of volatile organic compounds, (VOC's) less water per liter, and "is a compliant
coating with regard to VOC content requirement of the Bay Area,
Air Quality Management District," one of the strictly controlled air quality management districts in the U.S.A.
Need Adobe Acrobat Reader? 