Adhesion
Ceramic Cover CC Systems 100 has been tested for adhesion by tests corresponding to ASTM D-3359, a cross hatch adhesion test, resulting in a score of 100% (the highest on a scale of 1 to 100). Furthermore, Dunkin & Bush, Inc. an industrial paint contractor in Seattle, WA, performed an Elcometer Adhesion Test. Coating was spray applied using air assisted airless equipment.
The coating thickness ranges from 75 mils DFT to 45 mils DFT across the tested coupon on tightly adhered mil scale. The initial test was performed 20 days after application. The result was a pull strength of 210 psi at 74 mils DFT. The coating was disbonded leaving 3-6 mils on the substrate. The final pull test was performed about 30 days after final cure.
"...Ceramic Cover CC Systems 100 reaches full adhesive strength prior to final cure."The result was a pull strength of 210 psi at 45 mils DFT. The coating again disbonded leaving 3-4 mils on the substrate. Ceramic Cover CC Systems 100 has been tested under ASTM D4541 Test Method for pull of strength of Coating using portable adhesion testers. The conclusions are that Ceramic Cover CC Systems 100 reaches full adhesive strength prior to final cure. Further conclusion based on disbondment within the coating shows an actual stronger bond to the substrate surface.
Ceramic Cover CC System 100
Insulation
Test results have proven that one coat or 20 mil of Ceramic Cover CC Systems 100 eliminates radiant heat and reduces temperature greatly (60ºF to 80ºF degrees) on hot surfaces. Additional coats contribute a reduction in temperature between 40ºF to 45ºF.
Protection from UV Rays
Ceramic Cover CC Systems 100 can be applied directly over composites with 100% adhesion and no chemical adverse effect (i.e. tar roofing, asphalt shingles, paint, etc.) providing protection against UV Rays as well as insulating.
Adhesion
Ceramic Cover CC Systems 100 reaches full adhesive strength prior to final cure. Also based on disbondment within the coating, Ceramic Cover CC Systems 100 shows an actual stronger bond to the substrate surface.
Flame Resistance
Ceramic Cover CC Systems 100 flame spread is rated 5 out of 100 according to Southwest Research Institute, Department of Fire Technology in San Antonio, TX and MSDS sheet reports flash point noncombustible. Therefore, Ceramic Cover CC Systems 100 can be applied directly to hot surfaces in a wide temperature ranging from 34ºF to 400ºF without shut down.
Corrosion Protection
Ceramic Cover CC Systems 100 has no air pockets, therefore it impedes condensation, stops corrosion and has no loss of insulation properties when wet.
Condensation
Ceramic Cover CC Systems 100 has properties that are impervious to the environment such as a fungal-pesticide resistance - rating of 10 on a scale of 1 to 10 (10 being the highest). Additional tests have been administered: wind driven rain, hot/cold cycling, and chemical resistance. In each test and/or analysis, Ceramic Cover CC Systems 100 "tested in the highest percentiles" of available products.
Chemical Resistance
Ceramic Cover CC Systems 100 is an 84% solid latex high density material low in viscosity coating with high insulating properties and chemical resistance.
Chemical Content
Harland Associates Research Lab in San Francisco, CA, reports Ceramic Cover CC Systems 100 as having
0 (zero) grams of volatile organic compounds, (VOC's) less water per liter, and "is a compliant
coating with regard to VOC content requirement of the Bay Area,
Air Quality Management District," one of the strictly controlled air quality management districts in the U.S.A.
Need Adobe Acrobat Reader? 